Packing Machine roller and the pulp slurry by a pin connection

Packing Machine roller and the pulp slurry by a pin connection between the cartridge and the brush roller and the plasma clearance fit between the pin relative movement can, two safety pin with torsion springs, Packing Machine as shown in Figure 3.

When in operation, Packing Machine the brush roll is face of pressure from the slurry, the wheel will appear with a gap between the box body, Whey it out, Packing Machine along with the rotation of the roller brush evenly Jiangsu on paper. When the movement to the end position, the roller left face, Packing Machine a spring roll pulp put under the brush, then the compacted casing, the gap between the two will be sealed, Whey will no longer flow.

Because brush syrup boxes are small, cannot accommodate too many Whey, Packing Machine and Packing Machine work continuously need more Whey, so the brush box Bu designed a pulp slurry input port, the available output slurry pipe with large Jiangsu connected to the container for a sufficient amount of Whey, shown in Figure 4. Packing Machine Indiscriminately four paddle lose volume

2 Packing Machine power and control part of the design

2.1 Packing Machine Selection of the stepping motor

Controlled stepper motor rotation requires three elements: the direction, angle and speed. Contains hardware drivers for power, Packing Machine depending on the direction of the direction of the controller sends a high or low level. Stepping angle depends on the controller sends the number of pulses.