Packing Machine photoelectric switch insensitive reaction

Phenomenon 4: Packing Machine photoelectric switch insensitive reaction . Reason: photoelectric switch sensor head may be due to dust is too thick or too low sensitivity due. Packing Machine Solution : Wipe off the dust photoelectric switch end , an increase in sensitivity. Wipe go 〗 〖 bSZ state . Phenomenon 5: block photoelectric but less than expected . Check: 1 ) Always indicate whether the red light ? Always available if the screw counterclockwise rotation sensitivity . 2 ) photoelectric switch photoelectric switch block red light No ?

If not lit measurable photoelectric switch voltage is normal ( should be 12V); measuring photoelectric switch signal line voltage is normal ( approximately 0V when blocked about not being blocked 11V when around ) , not normal need of replacement. Packing Machine Phenomenon 6 : cutting inaccurate reasons: too wet or caking materials , methods of operation is wrong. In addition, the material inside the hopper material level change too much.

Packing Machine grid voltage instability can cause inaccurate cutting . Phenomenon 7: Vibrator irregular vibrations Cause: There might be a power supply voltage is unstable or cause clutter . Recommendations with power supply, while not all the way there with a large power equipment . Phenomenon 8: Weighing not allowed Cause: There might cause loosening the locking pin vibrator oscillator and weighing hopper touch ( re- lock ) , or sensor is damaged ( replace sensor ) . Phenomenon 9: Packing Machine weighing hopper material leakage Cause: There might open the door turn cut nut loose , open the door spring off , or open time is set too small . Open position may deviate from the pivot arm (power off , go to the bottom of the arm ) . Phenomenon 10: electronic scale 0:00 unstable.